1

Hiya

I have 180 Devices from my old network iv imported into Spiceworks, They have gone in fine

What i cant seam to do is Get spiceworks to scan them all Automaticaly for inventory details without manual clicking rescan on each device

Im sure there is a simple solution im just not sure what it is

Thanks in advance for any help

Dylan

3 Spice ups
2

Under settings, Network scan, make sure you have the IP range under scan entries. Also check the scheduler.

3

Ahh just trying too scan specific device ID’s 180 of them

is there a way to coma seperate the host ID’s or simmiler too add them to the scan range

4

Check your Global Scan Settings (Settings->Network Scan->Scroll down to Global Scan Settings). Verify that “Scheduled scan” is set to “Enabled”.

Also check your Default Schedule settings (right above the Global Scan Settings).

5

You can separate multiple IP addresses by comma, but you have to use the correct syntax. For example, to scan the two IP addresses 192.168.1.10 and 192.168.1.25, enter the following in the “Device/Range:” field:

192.168.1.10,25

For more information, see the following link and scroll down to the “What Options Do I Have When Setting Up New Device Ranges?”:

http://community.spiceworks.com/help/Adding_New_Devices